EINHELL TP-MA 36/30 Li BL Manual De Instrucciones Original página 16

4. Technical data
Motor power supply: ............................... 36 V DC
Rated speed: .......................................5400 min
Max. wheel diameter (rated capacity): .... 125 mm
Mounting hole: ...................................... 22.2 mm
Channel depth: ...................................... 5-30 mm
Channel width: ...................................... 8-30 mm
Mounting spindle thread: ................................ M8
Weight: .....................................................4.25 kg
Important!
The equipment is supplied without rechargeable
batteries and without a charger and is allowed to
be used only with the lithium-ion batteries of the
Power X-Change series!
The lithium-ion batteries of the Power X-Change
series are allowed to be charged only with Power-
X chargers.
Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ........................ 90 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ........................ 101 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
Anl_TP-MA_36-30_Li_BL_SPK13.indb 16 Anl_TP-MA_36-30_Li_BL_SPK13.indb 16
-1
= 8.46 m/s
2
h
2
- 16 -
GB
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Warning!
Always remove the battery pack before making
adjustments to the equipment.
5.1 Setting the groove depth (Fig. 8)
•
Slacken the locking screw (6).
•
Set the depth stop (7) to the desired depth.
•
Tighten the locking screw (6).
5.2 Fitting the dust extractor adapter (Fig. 3)
Caution! For health and safety reasons it is
imperative that you use a dust extractor. The
extractor socket is suitable for use on vacuum
extractor units (vacuum cleaners). The extractor
unit must be suitable for the extraction of fi ne
dust.
Connect a suitable vacuum cleaner, as shown in
Fig. 3, to the dust extraction connector.
29.05.2024 08:37:20 29.05.2024 08:37:20