Publicidad
Idiomas disponibles
Idiomas disponibles
en
16
OPERATION
Fuel Mixture
29
2-Cycle Engine Oil (25:1) 4%
Gasoline
1 Gallon (US) . . . . . . . . . . . . . . . . . . . . . . . . . . 5.2 oz.
1 Liter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 cc (40 ml)
2-Cycle Engine Oil (50:1) 2%
Gasoline
1 Gallon (US) . . . . . . . . . . . . . . . . . . . . . . . . . . 2.6 oz.
1 Liter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 cc (20 ml)
Filling the Tank
WARNING: Follow safety instruction for fuel
handling. Always shut off engine before fuelling.
Never add fuel to a machine with a running or hot
engine. Move at least 10 feet (3 m) from refuelling
site before starting engine (Fig. 29). DO NOT
SMOKE!
1. Clean surface around fuel cap to prevent contamination.
2. Loosen fuel cap slowly.
3. Carefully pour fuel mixture into the tank. Avoid spillage.
4. Prior to replacing the fuel cap, clean and inspect the gasket.
5. Immediately replace fuel cap and hand tighten. Wipe up any
fuel spillage.
WARNING: Check for fuel leaks, if any are found,
correct before use. Contact a Servicing Dealer if
necessary.
Preparation for Cutting
WARNING: When using rigid blades (only S and T
models), avoid cutting close to fences, sides of buil-
dings, tree trunks,
31
that could cause the brush cutter to kick out or could
cause damage to the blade. We recommends use of
the nylon line heads for such jobs. In addition, be
alert to an increased possibility of ricochets in such
situations.
WARNING: The brush cutter is normally to be used at
ground level with the cutting attachment parallel to
the ground. Use of a brush cutter above ground level
or with the cutting attachment perpendicular to the
ground may increase the risk of injury, since the
cutting attachment is more fully exposed and the
brush cutter may be more difficult to control. Never
use your brush cutter as a hedge trimmer.
32
Oil
Oil
stones or other such objects
Publicidad
