Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
7
8
This Wet/Dry Vac has blowing capabilities. To use the blower feature, follow the instructions listed
below.
WARNING:
IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
CAUTION:
WARNING:
INHALED.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from
the hose and collection tank.
3. Remove the hose from the vacuum port. Remove the noise diffuser from the blower port.
4. Insert the locking end of the hose into the blower port on the back of the powerhead and lock
into place (Fig. 2).
5. Choose the desired accessory and insert onto the end of the hose (Fig. 3).
6. Verify that the switch is in the 'O' OFF position before plugging the power cord into the power
outlet. Plug the power cord into the outlet (Fig. 4 & 5).
7. Before turning on the vacuum, firmly hold the loose end of the hose. Turn the vacuum on by
flipping the switch to the 'I' ON position (Fig. 6).
8. The unit will now blow through the vacuum hose and can be used to clear obstructions within
the hose (Fig. 7).
9. Once you have completed blowing, flip the on/off switch to the 'O' OFF position and unplug the
power cord from the outlet (Fig. 8).
BLOWER OPERATION
3
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
5
4
12
6
Publicidad
