Vacmaster VFB511H 0201 Manual Del Usuario página 8

GENERAL ASSEMBLY INSTRUCTIONS
A Phillips head screw driver is required.
1 2
8
7
13 14
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the powerhead off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on page 7 (Fig. 4).
5. Turn the collection tank upside down and insert the four casters into the sockets on the bottom
of the base. Press casters down until they snap into place (Fig. 5).
6. Insert the handle into the slots located on the top of the powerhead and secure it with the
screws provided. Do not over-tighten the screws (Fig. 6).
7. Your vacuum comes ready for dry vacuum cleaning. If the cartridge filter is not installed, refer
to page 14 for installation instructions (Fig. 7 & 8).
8. Optional: For improved dust filtering, fit the collection bag flange onto the inlet port, taking care
not to damage the bag. For installation instructions, see page 14 (Fig. 9).
NOTE: The dust collection bag is for dry pick-up only.
9. For wet vacuum cleaning, remove the cartridge filter, and install the supplied foam wet filter.
See page 15 for the foam wet filter installation instructions (Fig. 10).
10. Place the powerhead back on the collection tank (Fig. 11).
11. Position the hose storage rack as illustrated. Insert one side of the rack into the channel
making sure it is secured in place. Squeeze in the other end and insert it into the
corresponding channel making sure it is secured (Fig. 12 & 13).
12. Align the top section with the latches, and snap into place (Fig. 14).
13. Insert the locking end of the hose into the vacuum port on the collection tank and turn
clockwise to lock into place (Fig. 15).
14. Choose the desired accessory and insert onto the free end of the hose or extension wand (Fig.
16).
3
9
15
1 1
2 2
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
4 5
10 11
16
8
6
12