Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT:
1.
Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
NOTE: Receiver in controllers system features an
automatic learning function. There are no frequency
switches on the receiver unit. The receiver will
automatically scan the frequency from the hand held
control if an changes are made. the frequency settings
should be changed only in the case of interference or
if multiple ceiling fans with the same type of control
system are installed in the same structure.
3. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Then follow the remote code setting process.
(If not used for long periods of time, remove battery to
prevent damage to transmitter). Store the remote away
from excessive heat or humidly. (Figure 3)
4. If you have multiple fans and want to program all
fans to one handheld control, connect all fans to their
power supply in the ceiling and follow Step 1 of the
remote control set up process. Each fan needs to be
no more than 30 feet from the handheld control that
you would like to program. Please note the wall switch
that controls the power to your fan(s) should be in the
off position until you are ready to program your
handheld remote(s).
5. If you have multiple fans and want to program each
fan to separate handheld controls, connect one fan at
a time to their power supply in the ceiling and follow
Step 1 of the remote control set up process below.
Before you connect the second fan to its power
that was wired and programmed from the power
supply in the ceiling. Repeat these steps for each fan
that you would like to program to a separate handheld
remote. Please note that the wall switch that controls
the power to your fan(s) should be in the off position
until you are ready to program your handheld
remote(s).
How to Operate Your Ceiling Fan
WARNING
Solo para referencia visual-no ha sido
diseñado para cubrir todos los tipos de
controles
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
If you are not expecting to use the remote for a long
period of time, remove the battery to prevent damage
to the remote. Be sure to store the remote away from
excess heat or humidity.
13
Figure 1
MAIN FUSE BOX
Figure 2
WARNING
Figure 3
CAUTION
Publicidad
