Publicidad
Idiomas disponibles
Idiomas disponibles
How to Operate Your Ceiling Fan (continued)
6. Follow these steps to pair your remote control to your
fan. (Figure 4)
1) After installing and wiring the unit, restore power to
your fan by ensuring that the breaker and wall switch
that controls the power supply is moved to the on
position, press and hold the "SET" button inside of the
battery compartment of the handheld remote control for
1-5 seconds.
2) You must press the "SET" button within 60 seconds
of restoring power to the fan.
3) When restoring power to your fan at the wall switch
and breaker, DO NOT press any button(s) on the
handheld remote control before pressing the "SET"
button, otherwise the fan will fail the learn procedure.
4) If you press any button(s) on the handheld remote
control before pressing the "SET" button, please turn the
wall switch that controls the power to the fan to the off
position then on again, and start the process beginning
with Step 1 above.
5) When you press the "SET" button the fan will start to
run beginning the control set up process.
6) DO NOT press any button(s) after pressing the SET
button while the fan is programming or it will fail to
program.
7. The remote buttons instruct as below:
Fan speed:
I = minimum speed
III = medium low speed
V = medium high speed
: Turns the fan off.
: Controls fan direction - forward and reverse.
: Controls light-Infinite light levels are available by
holding the light on/off button (Figure 5).
NOTE: The light kit is optional, not included in the fan box.
8. "D" and "ON" dip switch:
For this fan, switch should be in the "ON" position, allowing
for dimming of the light. (Figure 6)
The receiver provides the following protective function:
Lock position: The DC motor has a built-in safety feature
against blade obstruction against obstruction during
operation. If something obstructs the fan blades the motor
will stop operating after 30 seconds of interruption. Please
remove obstacles and reset.
Over 80W protection: When the receiver detects motor
power consumption which is greater than 80W, the
receiver power will shutdown and fan operation will cease.
Disconnect the power supply and after 5 seconds return-
power on to the fan.
II = low speed
IV = medium speed
VI = high speed
7) The fan will run in both directions (forward and
reverse) for approximately 5 minutes.
8) When the fan stops running after approximately 5
minutes, that means that the handheld remote control
and speed set up process is complete.
9) The fan is now ready for normal use.
14
Figure 4
Figure 5
Figure 6
Publicidad
