• Temporary Appliance Load Reduction (L4): The refrigerator responds to a TALR signal
by aggressively reducing the load for a short time period. This function reduces energy
consumption by stopping the compressor and controlling the functions that consume a
lot of energy such as the defrost cycle and making ice.
- When the refrigerator operates in TALR (L4) mode, turn on the "TALR" icon on the
refrigerator display.
- TALR (L4) mode is automatically deactivated after it lasts for the received duration
(max. 15 minutes), or when the Override key is pressed. The mode is immediately
deactivated and the refrigerator returns to the normal state when the door is
opened or closed, or the dispenser is used.
To check the MAC address
1. In this mode, the MAC address appears on the temperature panel sequentially for
1 minute.
Press and hold both Fridge and Filter Reset for 6 seconds. The temperature display
blinks. Then, press Control Lock to display the MAC address. The fridge beeps.
2. For example, if the MAC address is "11-22-33-44-55-66", the temperature panel
displays the address for 1 minute in this sequence: "--" "11" "22" "33" "44"
"55" "66" "--".
After the 1 minute, the MAC address disappears and the temperature panel returns to
the normal state.
NOTE
The temperature panel displays "-- / --" for an unknown MAC address or if a Wi-Fi
connection is not established or is lost.
Override Mode
When you want the refrigerator to ignore the SMART GRID (Demand Response) signal
from the utility company, you can activate OVERRIDE mode.
When you activate OVERRIDE mode, the refrigerator ignores the SMART GRID (Demand
Response) signal and is not controlled by the utility company.
Activating and deactivating Override mode
1. Press and hold Override for 3 seconds.
2. A chime sounds with a message of 'Or' on the temperature display for 5 seconds. The
Override indicator (
3. If the refrigerator receives a SMART GRID (Demand Response) signal from the utility
company, `Or' is displayed in the fridge temperature display.
4. To deactivate OVERRIDE mode, press and hold Override for 3 seconds.
5. A chime sounds with a message of 'Or' on the temperature display for 5 seconds. The
Override indicator (
Dacor_BRR9000M_REF_DA68-03607B-07_EN.indd 29
) turns on.
) turns off.
English 29
2020-12-11
4:45:48