8. Mopping mode
NOTICE!
Possible material damage!
Floor coverings may be damaged by leaking
water/liquids.
Only use the robot vacuum and mop on
tiles and sealed floor surfaces, not on
carpets.
NOTICE!
Possibility of damage to the appliance!
Unsuitable additives in the water can cause
damage to the appliance.
Use only fresh tap water.
8.1. Preparing the water
tank
Remove the dust container with water
tank.
Fig. 13 – Removing the water tank
Open the cap on the water tank.
Fig. 14 – Filling the water tank
Fill the water tank with tap water.
148
Moisten the mop attachment with water
and wring it out until it stops dripping.
Fig. 15 – Attaching the mop attachment
Slide the mop attachment into the guide
rail of the mopping device.
Fig. 16 – Pressing on the mop attachment
Firmly press the mop pad onto the
mounting pads on the bottom of the
water tank.
Place the robot vacuum and mop back
on its wheels.
Place the dust container with water tank
and mopping device back in the robot
vacuum and mop.
Fig. 17 – Inserting the mopping device
Press the
button to start wet
cleaning.
Empty the water tank and rinse out the
mop attachment after every wet cleaning
and allow it to dry.