Parkside PLDM A1 Instrucciones De Utilización Y De Seguridad página 55

4 . Release all buttons .
5 . Press the UNIT button to select NFe or Fe test mode .
6 . Press and hold the probe
surface of the naked substrate
from the substrate once the display
display shows the reading 1 .80 mm .
7 . Press the TEST button to increase the reading on the
display .
8 . Press the UNIT button to decrease the reading on the
display .
NOTE: The reading should equal the thickness value of
the calibration plate
the calibration plate is 1 .76 mm, press the UNIT button to
decrease the reading on the display to 1 .76 mm .
9 . Place the calibration plate onto the naked substrate .
perpendicularly against the
1 ] [
. Move the product away
8 ] [
. For example, if the thickness of
7 ] [
shows
2 ] [
GB/IE
. The
55