MESTIC SMART ADVENTURE MI-500 Instrucciones De Uso página 31

Wires and circuit breakers for the AC output and AC input:
Model
MI-500 1mm²/18AWG
MI-1000 1.5mm2/15AWG
MI-1500 1.5mm2/15AWG
MI-2000 2.5mm²/13AWG
MI-3000 4mm2/11AWG
4. Note: The above wire size and circuit breaker size are for reference only; please choose a suitable
wire and circuit breaker according to the actual situation. If there is a considerable distance
between the inverter and the battery, use larger wires to minimize voltage drop and enhance
system performance.
Mounting
Location:
1. The inverter should be installed in a location with ample airflow through the dissipation pad. It is
recommended to maintain a minimum clearance of 150mm around the inverter to ensure
natural thermal convection.
2. Note: Avoid installing the product in an enclosed cabinet where device cooling may be
compromised. If mounted in an enclosed cabinet, ensure effective ventilation and do not turn on
all loads simultaneously. Failure to do so may activate the device's over-temperature protection.
Wiring
1. Turn off the inverter before wiring.
2. Do not connect the circuit breaker or fast-acting fuse during wiring, and ensure that the pole
leads are connected correctly.
3. Note that the terminals and ports on the side may vary among product models.
4. The following wiring sequence is illustrated in the appearance of "MI-2000"; wiring positions of
other inverters may differ.
Ground connection:
1. The wire size for the ground connection must be thicker or equal to that for the AC output. Refer
to the chapter " Wire size and circuit breaker" for detailed wire size information.
Wire size Circuit breaker
AC/2P—6A
AC/2P—10A
AC/2P—10A
AC/2P—16A
AC/2P—25A