MESTIC SMART ADVENTURE MI-500 Instrucciones De Uso página 38

repeat the above operation. Note: The setting parameter cannot exceed the user-defined limit
(see table below), or else it will return to the initial value to start the loop.
7. Press and hold the
Other parameters:
1. In the real-time interface, press
2. Click or to select the parameter to be configured.
3. Press for 2s to enter the configuration interface of the specified parameter.
4. Click or to configure the parameter value.
5. Press for 2s to confirm the configuration.
6. Click + to exit the current interface.
User-defined parameters:
Display
Output voltage class
Output frequency class
Power Saving Enable
Low voltage disconnect
Low voltage reconnect
Over voltage reconnect
Over voltage disconnect
1) After configuring the parameters marked with
work according to the new parameter values.
2) Can be used to set the length limit of the displayed data on the screen. When the baud rate is set to
115200, the value displayed on the LCD is 1152.
3) For the parameters marked with
"Protection". Otherwise, the parameter settings will not succeed.
button to confirm.
for 2s to enter the parameter setting interface.
Parameters
1)
1)
LCD backlight time
Power Saving In
Power Saving Out
2)
Baud Rate Select
3
voltage )
3)
voltage
3)
voltage
3)
voltage
3)
: please set them following the input voltage rules in the chapter
Default
230VAC 220VAC/230VAC/240VAC
50Hz
30s 30s/ 60s/100s(ON solid)
OFF
20VA 20VA ~ (20%*rated power)
40VA (20VA + PSI) ~ (50%*rated power)
115200
10.8V 10.5V~14.2V; step size 0.1V
12.5V 11.5V~15.2V; step size 0.1V
14.5V 11.5V~15.2V; step size 0.1V
16V 10.5V~14.2V; step size 0.1V
1)
, the inverter will restart automatically. It will resume
User-defined
50Hz/60Hz
ON/OFF
9600/115200