MESTIC SMART ADVENTURE MI-500 Instrucciones De Uso página 37

Power saving mode:
1. Users can activate the power-saving mode and set the PSI/PSO value using the remote inverter
display. (The minimum power level is 1VA.)
2. When the actual load power is lower than the PSI (the power to enter the power-saving mode),
the system will automatically switch to the power-saving mode. In this mode, the device output is
turned on for 1s and then turned off for 5s.
3. If the actual load power exceeds the PSO (the power to exit the power-saving mode), the inverter
will automatically exit the power-saving mode and resume normal operation.
Enable power saving mode (PSE):
1. In the real-time interface (the default interface after the device is powered on) of the remote
inverter display, press and hold the
2. Press the or
3. Press and hold the
4. Press the or
5. Select ON to enable the power saving mode.
6. Select OFF to disable the power saving mode.
7. Press and hold the
Set the power to exit the power saving mode (PSO):
1. In the parameters setting interface, press the
2. Press and hold the
3. Press the or
4. Press the button to decrease the PSO value by 1.
5. Press the button to increase the PSO value by 1.
6. Press and hold the
value will increase by 100 each time. When the
repeat the above steps. Note: The setting parameter cannot exceed the user-defined limit (see
table below), or else it will return to the initial value to start the loop.
7. Press and hold the
Set the power to enter the power saving mode (PSI):
1. In the parameters setting interface, press the
2. Press and hold the
3. Press the or
4. Press the button to decrease the PSI value by 1.
5. Press the button to increase the PSI value by 1.
6. Press and hold the
value will increase by 100 each time. When the
button to enter the parameters setting interface.
button to select the PSE parameter.
button until the PSE parameter (OFF default) flashes.
button to set the PSE state.
button to confirm.
button until the PSO value flashes.
button to set the PSO parameter.
button to increase the PSO value by 10. After adding ten times, the PSO
button to confirm.
button until the PSI value flashes.
button to set the PSI parameter.
button to increase the PSI value by 10. After adding ten times, the PSI
or button to select the PSO parameter.
button is released, press and hold it again to
or button to select the PSI parameter.
button is released, press and hold it again to