MSW Motor Technics MSW-SBBD-2800MAX Manual De Instrucciones página 57

• To start the machine, press the green "I" (On) button on the power
switch and the cutting blade will start to rotate.
IMPORTANT: Wait for a while after switching on the machine before
making any cuts so that the cutting blade can reach full operating
speed.
To turn off the machine, press the "O" (Off) button on the power
•
switch.
IMPORTANT: turn the machine off only after the workpiece has been
cut. After switching off, the cutting disc will continue to run for a
while.
3.3.2 Adjusting the height/angle of the blade
a) Blade height indicator
b) Blade tilt indicator (bevel angle)
c)
To set the desired height of the blade (cutting), adjust it with the
•
knob located at the bottom of the worktop. The scale indicates the
height of the blade above the worktop.
• To adjust the angle of the blade, release the knobs that fix them at
both ends of the device, then tilt the cutting disc and the drive at the
desired angle - see the indicator under the worktop. Then tighten the
blade angle knobs again.
3.3.3 Adjustment of the parallel guide
Blade height adjustment knob
EN