Publicidad
Idiomas disponibles
Idiomas disponibles
•
Release the levers holding the parallel guide bar and set the
desired distance according to the marked scale by sliding the bar
along the worktop (see the picture above).
After setting the guide bar in the desired position, again tighten
•
the levers.
3.3.4
Adjustment of the cross guide
Loosen the lever of the cross rail and set the guide at the desired
•
angle according to the scale (see the picture above).
After setting the desired angle, again tighten the lever holding
•
the guide mechanism.
If necessary, you can dismantle the angle guide by loosening the
•
2 wing nuts holding it or move it in a different direction or fix it
EN
Publicidad
