Publicidad
Idiomas disponibles
Idiomas disponibles
▸
Prior to first use always read the safety instruc-
tions!
— Failure to observe the operating instructions and
the safety instructions could result in damage to
the device and danger for the operator and other
persons.
▸
All persons involved in the commissioning, op-
eration and maintenance of the device must be
appropriately qualified.
▸
The safety instructions must not be lost – give
them to the operator.
Danger due to ejected parts
piece or an accessory or even the tool itself, parts
can be thrown out at high speed.
▸
When using the threaded fastener tool, always
wear impact-resistant eye protection. The level of
protection required should be specially assessed
for every particular use.
▸
It must be ensured that the workpiece is safely
secured.
hazards due to entanglement/
drawing in
▸
Hazards due to entanglement/drawing in can
lead to suffocation, scalping and/or cutting
injuries, if loose clothing, personal jewellery, neck
chains, hair or gloves are not kept away from the
tool and its accessories.
▸
Gloves can get caught in the rotating drive,
which can lead to injuries or fractures of the
fingers.
▸
When using rotating drive sockets and extension
bars, the entanglement/drawing in of rubber or
metal-reinforced gloves can occur easily.
▸
Do not wear loose-fitting gloves or gloves with
cut-off or worn glove fingers.
▸
Never hold the drive, socket or drive extension.
▸
Keep your hands away from the rotating drive.
General safety instructions
▸
Tools must be maintained regularly, to check that
the rated values required from the present part of
ISO 11148 and labels are legible and indicated
on the machine. The employee/user must contact
the manufacturer to obtain replacement identifi-
cation labels as necessary.
▸
Never use a damaged threaded fastener tool.
▸
Use only genuine Würth accessories and
spare parts.
Special safety instructions
operating hazards
of the work-
▸
When using the tool, the operator's hands are
exposed to hazards due to crushing, impacts,
cutting, friction and heat. Wear suitable gloves to
protect the hands.
▸
The operators and maintenance personnel must
be physically strong enough to handle the weight
and power of the tool.
▸
Hold the tool correctly: Be ready to counter any
normal or sudden movements - have both hands
ready.
▸
Ensure your body is balanced and that you are
standing securely.
▸
Release the hold-to-run control device to start-up
or stationary in the event of a power supply
outage.
▸
Use only the lubricants recommended by the
manufacturer.
▸
In cases in which aids are necessary to absorb
the reaction torque, it is recommended that a
hanger is used whenever possible. If this is not
possible, side grips are recommended for tools
with a straight grip and machines with a pistol
grip. In all cases, it is recommended that aids are
used to absorb the reaction torque if it is greater
than 4 Nm for tools with a straight grip, greater
than 10 Nm for tools with a pistol grip and
greater than 60 Nm for angle drivers.
▸
Fingers may be crushed in nut wrenches with an
open flat head.
13
Publicidad
