Publicidad
Janome 639X Instruction Manual
1
1
(B)
(C)
2
3
6 7
1
2
1
3
www.toews.com
3
2
(A)
4
5
2
SECTION 5. BUTTONHOLES
Buttonhole
1
Stitch selector:
2
Needle thread tension:
3
Presser foot:
• Starting to sew
Attach the buttonhole foot. Carefully mark the
buttonhole length on the fabric.
Place the fabric under the foot, with the button
hole marking running toward you.
Move the slider (A) toward you so the top mark
(C) on the slider aligns with the start mark (B).
Lower the presser foot.
Set the stitch selector at
you reach the front mark of your buttonhole. Stop
sewing at a left stitch.
Set the stitch selector at
(6) stitches. Stop sewing at a right stitch.
Set the stitch selector at
return to the start mark of the buttonhole. Stop
sewing at a right stitch.
Set the stitch selector at
(6) stitches. Stop sewing at a left stitch.
Remove the fabric and place a pin just before
the bartack at each end to prevent cutting
bartacks. Cut the opening with the buttonhole
opener.
NOTE:
When sewing a buttonhole at the edge of a
fabric, set the sliding buttonhole foot as
illustrated and sew in reverse [
Corded Buttonhole
With the buttonhole foot raised, hook the filler cord on
1
the spur at the back of the buttonhole foot.
Bring the ends toward you under the buttonhole foot,
clearing the front end.
Hook the filler cord into the forks on the front of the
buttonhole foot to hold them tight.
Spur
1
Forks
2
Sew the buttonhole over the cord in the same
2
procedure as above.
Remove the fabric from the machine and cut the
sewing threads only.
3
Pull the left end of the filler cord to tighten it.
Thread the end through a darning needle, draw to the
wrong side of the fabric and cut.
28
4
1
3
2
1 to 5
Sliding buttonhole
foot
1
. Sew forward until
4
. Sew four (4) to six
2
. Sew until you
3
4
. Sew four (4) to six
2
4
3
1
2
639X Owners Manual/ User Guide
4
].
2
Publicidad
