Renfert 1840 0000 Instrucciones Para El Servicio página 17

2.3 Ambient Conditions for Safe Operation
The device may only be operated:
• Indoors
• Up to an altitude of 2,000 m above sea level,
• At an ambient temperature of between 5 - 40 ºC [41 - 104 ºF] *),
• At a maximum relative humidity of 80 % at 31 ºC [87.8 ºF], dropping to a linear of up to 50 %
• Relative humidity at 40 ºC [104 ºF] *),
• With mains power where the voltage fluctuations do not exceed 10 % of the nominal value,
• Under contamination level 2 conditions,
• Under over-voltage category II conditions,
*) Between 5 - 30 ºC [41 - 86 ºF] the device can be operated at a relative humidity of up to 80 %. At temperatures between
31 - 40 ºC [87.8 - 104 ºF] the humidity must decrease proportionally in order to ensure operational readiness (e.g. at
35 ºC [95 ºF] = 65 % humidity, at 40 ºC [104 ºF] = 50 % humidity). The device may not be operated at temperatures
above 40 ºC [104 ºF].
2.4 Ambient Conditions for Storage and Transport
For storage and transport the following specifications to ambient conditions apply:
• Ambient temperature - 20 – + 60 ºC [-4 – + 140 ºF].
• Maximum relative humidity 80 %.
2.5 Hazard and Warning Information
2.5.1 General Information
► If the device is not used in compliance with the supplied instructions, the safety of the device
can no longer be guaranteed.
► The device may only be operated using a mains cable with the country-specific plug system.
Any necessary alterations must be carried out by a qualified electrician.
► The device may only be operated if the information on the identification plate conforms to the
specifications of your local mains power supply.
► The device may only be plugged into outlets which are connected to the protective conductor
system.
► The mains plug must be easily accessible.
► Disconnect the device from the mains before carrying out work on the electrical parts.
► It is the responsibility of the operator that national regulations during operation and regarding
a repeated safety inspection of electrical equipment are complied with. For Germany these are
the regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE (Associa-
tion for Electrical & Electronic Technology) 0701-0702.
► Check connection cables (such as power supply cords), tubes and housing (i.e. the key-pad)
regularly for damage (i.e. kinks, cracks and porosity) or signs of ageing.
Devices with damaged connection cables, tubes or housing parts or other defects must not be
operated!
► Defective devices must be put out of service immediately. Remove the mains plug and ensure
the device is not used. Send the device for repair!
► Only operate the device under supervision.
► Please observe the national accident prevention regulations!
2.5.2 Specific Instructions
► Caution! Laser beam! Laser class 2! Do not look into the laser beam!
► Do not use the device for milling. Risk of injury if the drill breaks.
► Never touch the drill when the unit is connected to the power supply. There is a risk of injury if
the unit is accidentally activated!
► Do not operate theTop spin with long, untied hair or loose / baggy clothing. If anything gets
tangled up or drawn in there is a risk of injury.
► Do not touch the drill when in motion.
► The unit should only be activated when the model is securely placed in position
► When drilling, do not hold the model directly over the laser beam - risk of injury.
- 3 -
EN