Publicidad
Idiomas disponibles
Idiomas disponibles
8
ADJUSTMENTS
8.1
HEIGHT OF CUT
The height of cut can be set between: 3/4" (19mm) -
5 1/4" (133mm) in 1/4" (6mm) Increments.
1.
Examine the decals on the cutter deck to
determine which pin position is correct for
the height of cut desired.(A)
2.
If changing the height of cut from the
existing position:
a.Remove the cotter pin and washer
securing the two height of cut pins (B) at
one side of the deck.
b.Grasp a handle on the top of the deck
(C) and simultaneously remove the height
of cut pins.
c.While still holding the handle, guide the
deck so that the height of cut pins can be
reinserted into the desired positions.
d.resecure the height of cut pins with the
cotter pins and washers.
3
repeat with the height of cut pins on the
other side of the deck.
4.
repeat steps 2 and 3 for all other cutter
decks, setting the same height of cut
throughout.
GB-22
JACOBSEN AR250 Series CE
SAFETY AND OPERATORS MANUAL
Publicidad
