Publicidad
Idiomas disponibles
Idiomas disponibles
You can adjust the SenseFry level by
pressing one of the corresponding heat
setting levels as seen in the table below.
SenseFry pow‐
er level
Low
Medium
High
The function starts.
Once the function starts the indicators above
the slider appear and the animation starts
running.
If you do not place a pot on any of the
cooking zones within 5 seconds, the
function deactivates automatically.
6. Set a timer function, if needed.
Once the pan reaches the intended
temperature an acoustic signal sounds. You
can put oil and food inside the pan now.
To stop the function press 0 on the control
bar or press
.
If you set a Count Down Timer on one of the
cooking zones and the set time runs out
before the intended temperature is reached
the function deactivates automatically.
Hints and tips:
• You can change the default heat level, if
needed.
• For thick pieces of food or raw potatoes
use a lid during the first 10 min of frying.
• Heavy and / or large pans may take longer
to heat up.
• Use laminated pans with low heat level to
prevent overheating and damage of the
cookware.
• Do not use thin enamelled cookware. It
can be overheated and damaged.
Correct pans for SenseFry function
Use only pans with flat bottoms. To check if
the pan is correct:
1. Put your pan upside down.
2. Put a ruler on the bottom of the pan.
3. Try to put a coin of 1, 2, or 5 Euro Cent
Heat setting
levels
2
5
8
6.10 SenseBoil®
The function automatically adjusts the
temperature of water so that it does not boil
over once it reaches the boiling point.
(or any coin with similar thickness,
approx. 1.7 mm) between the ruler and
the bottom of the pan.
a. The pan is incorrect if you can put the
coin between the ruler and the pan.
b. The pan is correct if you cannot put
the coin between the ruler and the
pan.
If there is any residual heat (
on the cooking zone you want to use, an
acoustic signal sounds and the function
does not start.
The function does not work with non-stick
cookware.
/
/
)
ENGLISH
13
Publicidad
