HomeMatic IP HmIP-WTH-B-2 Manual De Instalacion Y Uso página 28

Start-up
6.1.2 Pairing with other
Homematic IP devices
To connect the wall thermostat with
another Homematic IP device, the
pairing mode of both devices has to be
activated. To do this, please proceed as
follows:
• Open the battery compartment (G)
using a slotted screwdriver to loo-
sen the wall bracket
• Remove the insulation strip from
the battery compartment of the
wall thermostat.
• Press and hold down the system
button (C) for at least 4 seconds to
activate the pairing mode. The de-
vice LED (C) starts to flash orange.
Pairing mode remains activated for
3 minutes.
4 s
Figure 5
• Press and hold down the system
button of the device you want to
connect (e.g. the radiator thermo-
stat – basic) for at least 4 seconds
to activate the pairing mode. The
device LED starts to flash orange.
For further information, please re-
fer to the operating manual of the
corresponding device.
• If pairing was successful, the LED
lights up green.
(see figure).
6.2 Pairing to the Homematic IP
Access Point
You can connect the device either
to the Homematic IP Access Point
or the Central Control Unit CCU3.
For detailed information, refer to
the Homematic IP User Guide,
available for download in the
download area of
www.homematic-ip.com).
First set up your Homematic IP
Access Point via the Homematic IP
app to enable operation of other
Homematic IP devices within your
system. For further information,
refer to the operating manual of
the Access Point.
After pairing the wall thermostat
to the Homematic IP Access Point,
the menu of the wall thermostat
will be hidden and settings can be
adjusted only via the
Homematic IP app.
To integrate the wall thermostat into
your system and to enable control via
the Homematic IP app, you must add
the device to your Homematic IP Ac-
cess Point first. To do this, please pro-
ceed as follows:
• Open the Homematic IP app on
your smartphone.
• Select the menu item "Add
device"(see figure 6).
• Open the battery compartment (G)
using a slotted screwdriver to loo-
sen the wall mounting plate
(see figure).
• Remove the insulation strip from
the battery compartment of the
wall thermostat.
28