HomeMatic IP HmIP-WTH-B-2 Manual De Instalacion Y Uso página 32

Configuration menu
equipment and, if necessary, per-
sonal safety equipment;
• Evaluation of measuring results;
• Selection of electrical installation
material for safeguarding shut-off
conditions;
• IP protection types;
• Installation of electrical installation
material;
• Type of supply network (TN sys-
tem, IT system, TT system) and the
resulting connecting conditions
(classical zero balancing, protective
earthing, required additional mea-
sures etc.).
7 Configuration menu
When using the wall thermostat wit-
hout Homematic IP Access Point, you
can select the following modes via
the configuration menu after set-up
directly on the device and adjust the
settings to your personal needs. To do
this, proceed as follows:
• By pressing and holding the menu
button (E) for at least 2 s, you will
be entering the configuration
menu.
• Select the desired icon via the plus
and minus buttons (D + F) by pres-
sing the menu button briefly to
change the settings of the different
menu items.
Press and hold down the menu
button (E) to get back to the pre-
vious level. The menu automati-
cally closes without applying
changes if there is no operation
for more than 1 minute.
7.1 Manual operation
In manual mode, the temperature is
controlled in accordance with the
current temperature set via the push-
buttons (D + F). The temperature re-
mains activated until the next manual
change. To activate the manual mode,
please proceed as follows:
• Press and hold down the menu
button (E) to open the configurati-
on menu.
• Select "Manu" via the plus and mi-
nus buttons (D + F) in the menu.
• Confirm with the menu button.
To confirm, the symbol flashes twice
and the device changes back to manu-
al mode.
7.2 Automatic mode
Switching from manual to auto-
matic mode is only possible if the
date and time have been set.
In automatic mode, the temperature is
controlled in accordance with the set
heating profile. Manual changes are
activated until the next point at which
the profile changes. Afterwards, the
defined heating profile will be activated
again. To activate the automatic mode,
please proceed as follows:
• Press and hold down the menu
button (E) to open the configurati-
on menu.
• Select "Auto" via the plus and mi-
nus buttons (D + F) in the menu.
• Confirm with the menu button.
To confirm, the symbol flashes twice
and the device changes back to auto-
matic mode.
32