Publicidad
Idiomas disponibles
Idiomas disponibles
Start-up
• Fix the adhesive strips on the back
side of the mounting plate in the
provided area. You should be able
to read the letters ("TOP") on the
back side.
2x
Figure 8
• Remove the protective film from
the adhesive strips.
Figure 9
• Press the assembled wall thermos-
tat with the back side to the wall in
the position where it should subse-
quently be attached.
Figure 10
6.3.2 Screw mounting
For mounting the wall thermostat by
screws, please proceed as follows:
• Choose a site for installation.
Make sure that no electricity or
similar lines run in the wall at this
location!
• Position the mounting plate on the
desired site on the wall. Make sure
that the arrows on the back side of
the mounting plate point upwards.
Use a pen to mark the positions of
the two bore holes according to
the mounting plate with a distance
of 60 mm on the wall.
60 mm
Figure 11
• Drill the marked holes.
Figure 12
If you are working with a stone
wall, drill the marked two 5 mm
holes and insert the plugs sup-
plied. If you are working with a
wooden wall, you can pre-drill
1.5 mm holes to make screws
easier to insert.
2x
30
Publicidad
