Publicidad
Idiomas disponibles
Idiomas disponibles
Start-up
• Pairing mode remains activated for
3 minutes.
You can manually start the pairing
mode for another 3 minutes by
pressing the system button (C)
shortly
Figure 6
Your device will automatically appear
in the Homematic IP app.
• Your device will automatically ap-
pear in the Homematic IP app.
• To confirm, enter the last four di-
gits of the device number (SGTIN)
in your app or scan the QR code.
Therefore, see the sticker supplied
or attached to the device.
• Wait until the connection is com-
pleted.
• If pairing was successful, the LED
(C) lights up green. The device is
now ready for use.
• If the LED lights up red, please try
again.
• Select the desired solution for your
device.
• Allocate the device to a room and
give the device a name.
6.3
Mounting
Please read this entire section
before starting to mount the de-
vice.
You can operate the wall thermostat
with
• the supplied double-sided adhesive
strips or
• the supplied screws
to fix it to a wall.
You can also mount the wall thermos-
tat on a flush-mounting box.
6.3.1 Adhesive strip mounting
For mounting the wall thermostat
using the adhesive strips, please pro-
ceed as follows:
• Choose a site for installation.
Make sure that the mounting sur-
face is smooth, solid, non-distur-
bed, free of dust, grease and sol-
vents and not too cold to ensure
long-time adherence.
• Insert the electronic unit (A) into
the mounting plate (see figure 7).
Make sure that the electronic unit
properly engages into the moun-
ting plate.
Figure 7
click
29
Publicidad
