RADEMACHER superrollo RM10MSB Instrucciones De Montaje Y Uso página 24

Starting up the device
Starting up the device
Establishing the radio link
The remote control included in the scope of delivery is used to control the motor's
electronics by radio. This chapter provides information on establishing the radio
link between the remote control and the motor.
The basic requirement for the remote control function is a charged battery in the
battery compartment on the rear side of the remote control.
The indicator LED lights up when a button is pressed.
The following overview shows the remote control's controls and displays.
UP button
STOP button
WARNING
Improper use leads to an increased risk of injury.
➢ Never use defective or damaged devices.
➢ Never use controllers with radio technology for the remote control of
de-vices and systems with increased safety-relevant requirements
or where there is an increased accident risk. Applications of this kind
require additional safety equipment. Observe the respective
statutory regulations for the installation of such systems.
WARNING
Risk of fire or explosion.
➢ Disposal of a battery into fire or a hot oven, or mechanically
crushing or cutting of a battery, that can result in an explosion;
➢ Leaving a battery in an extremely high temperature surrounding
environment that can result in an ex- plosion or the leakage of
flammable liquid or gas;
➢ A battery subjected to extremely low air pressure that may result in
an explosion or the leakage of flammable liquid or gas.
24
DOWN button
Indicator LED
Logging the radio transmitter onto the motor
➢ Switch the motor off and wait approximately 10 seconds.
➢ Switch the motor on again.
The motor starts up briefly.
➢ Press and hold the STOP button for 2 seconds.
The motor then acknowledges this by starting up briefly and emitting three
beeps
➢ Release the STOP button again. The log-on was successful.
Changing the rotation direction
If the button assignment does not match the movement the motor, the rotation
direction can be changed.
Observe the time limit
The rotation direction must be changed within 30 seconds of logging on to the
motor.
➢ Simultaneously press the UP and DOWN buttons and hold them for 2 seconds.
The motor starts up briefly.
➢ Release the buttons again. The change of rotation direction was successful.
Logging the radio transmitter off from the motor
➢ Switch the motor off and wait approximately 10 seconds.
➢ Switch the motor on again.
The motor starts up briefly.
➢ Press and hold the STOP button for 2 seconds.
The motor then acknowledges this by starting up briefly and emitting three
beeps.
Using the radio transmitter
➢ Press the UP button to move the roller shutter up.
➢ Press the STOP button to stop the roller shutter.
➢ Press the DOWN button to move the roller shutter down.
The indicator LED lights up when a button is pressed.