RADEMACHER superrollo RM10MSB Instrucciones De Montaje Y Uso página 25

Installing the roller shutter curtain
The following prerequisites must be met in order to be able to install the roller
shutter curtain:
■ The roller shutter curtain must lie in the guide rail.
■ The tubular motor must be run all the way down.
ATTENTION
Damage to the tubular motor due to drilling or screwing.
➢ Never drill or screw the winding shaft in the area of the tubular
motor.
➢ Use only the holes available in the winding shaft to secure the roller
shutter curtain.
➢ 1. Approx. every 40 cm, slide a securing spring (1) onto the top slat of the roller
shutter curtain (2).
➢ 2. Insert the securing springs into the rectangular holes (3) in the winding shaft.
If SW40 winding shafts with exterior fold are used, attaching clips are additionally
required.
➢ 1. Approx. every 40 cm, slide an attaching clip (1) over the winding shaft (2)
from above.
➢ 2. Insert the securing springs (4) into the rectangular holes in the attaching clips
(3).
Setting the terminal points
Setting the terminal points defines the upper and lower terminal positions for
raising and lowering the roller shutter. These settings can be subsequently
changed at any time.
The tubular motor is designed for short-term operation (four minutes). In
order to avoid damage due to heating, the motor shuts off automatically
on exceeding this period of time or in the event of frequent switching.
Allow the motor to cool for approx. 20 minutes in this case.
ATTENTION
Malfunctions due to missing or incorrect terminal point settings.
➢ Make sure that the device is only used with correctly set terminal
points.
The adjuster screws are located on the tubular motor's driving head.
➢ Use the upper screw (1) to set the lower terminal point.
➢ Use the lower screw (2) to set the upper terminal point.
➢ In order to extend the travel, turn the screw in the PLUS direction.
➢ In order to shorten the travel, turn the screw in the opposite direction (MINUS).
The direction of rotation of the adjuster screws may vary depending on
the model. Pay attention to the labelling on the driving head.
ATTENTION
Damage to the device due to roller shutter curtain shortening as
a result of temperature fluctuations.
➢ Set the terminal points so that the roller shutter curtain stoppers
have approx. 2-3 cm clearance from the limit stops.
Proceed as follows to set the upper terminal point:
➢ Operate the motor to raise the roller shutter.
If the motor stops before the desired terminal point is reached, proceed as follows:
➢ Leave the remote control set to the raise position.
➢ Use the adjustment tool to carefully turn the lower adjuster screw in the PLUS
direction until the motor has reached the desired terminal point.
If the motor passes by the desired terminal point, proceed as follows:
➢ Stop the motor.
➢ Operate the motor to lower the roller shutter.
➢ Stop beneath the desired terminal point.
Starting up the device
25