Publicidad
Idiomas disponibles
Idiomas disponibles
EN Center Console Refrigerator
1.
Use a T20 Torx screwdriver to remove the single
screw at the bottom of the console lid bottom cov-
er.
2. Use a panel removal tool to pry up the bottom of
the cover until the clips disengage.
3. Depress the console lid button to disengage the
locking tabs from the console lid bottom cover.
4. Continue prying the console lid bottom cover up
until it is completely detached.
5. Set the console lid bottom cover aside.
8.3
Installing the refrigerator
2
① Rubber protective
piece
1.
Snap the two rubber protective pieces on the back
rail of the console bin.
2. Replace the rubber mat in the bottom of the con-
sole bin.
3. Plug the 12 V power plug into the 12 V power con-
nector.
4. Taking care to not damage the cooling system
components, lower the refrigerator into the con-
sole bin.
① Refrigerator
② Fan power connec-
tor
10
1
② Back rail
1
③ Screws
5. Use a #2 Phillips screwdriver to hand tighten the
screws until the refrigerator sits snuggly against the
console front rail.
6. Connect the fan power connector to the refrigera-
tor power connector and secure it out of the way
with a cable tie.
① Closeout tray
7.
Position the closeout tray in front of the refrigerator
and press down until it clicks into place.
8.4
Replacing the console lid bottom
cover
1.
Snap the console lid bottom cover on to the con-
sole lid.
2. Use a T20 Torx screwdriver to replace the single
screw at the bottom of the console lid bottom cov-
er.
8.5
Reinstalling the console back panel
2
3
1
1
Publicidad
