Publicidad
Idiomas disponibles
Idiomas disponibles
EN Center Console Refrigerator
7.3
Preparing the power connector
location
① Console back wall
1.
On the rear passenger side of the console, identify
the hole location for the 12 V power connector.
2. Using a marker, trace the opening on the power
connector template onto the wall.
3. Use the 1 1/8 in (29 mm) hole saw drill bit to drill an
opening for the 12 V power connector
4. Vacuum any debris from the console and console
bin area.
5. Place the refrigerator near the console bin.
6. Insert the end of the refrigerator's 12 V power plug
into the 1 1/8 in (29 mm) hole until it snaps into
place.
7.4
Preparing the front fan opening
2
1
① Front fan template
② 54 mm
8
2
1
② Power connector open-
ing
3
4
③ Console bin front wall
④ 100 mm
1.
Remove the rubber pad from the bottom of the
console bin.
2. Tape the front fan template to the inside, front wall
of the console bin.
3. Using a marker, trace the center point opening
from the template onto the console bin wall.
3
① 63.5 mm hole
② 3/8 in (10 mm) maxi-
mum drilling depth
4. Remove the front fan template.
5. Use a 63.5 mm hole saw drill bit to drill an opening
for the front fan taking care not to push the drill bit
into the space under the console.
NOTE It may be helpful to wrap two
bands of tape around the outside of the
hole saw drill bit to prevent it from going
too far into the console.
6. Vacuum any debris from the console and console
bin area.
7.5
Testing the refrigerator
1.
Plug the gray power connector into the refrigerator
power connector.
NOTE On models with rear heated
seats, the fabric wrap around the wiring
may need to be pulled back to give
enough slack for the gray power connec-
tor to reach the refrigerator power con-
nector.
2. Start the vehicle engine.
1
2
③ 63.5 mm hole saw
drill bit
Publicidad
