Hella Jumbo 320 FF Instrucciones De Montaje página 9

Page 4:
Electrical connection
Install relay with connection
terminals pointing downwards so
that they are protected against
splashing water.
If required, and legally permissible,
install switch in dashboard.
Reconnect earth lead (-) to battery.
Check lights, tighten connection
wires securely.
Page 5: Accessories
(not included with kit)
1. Bulb for H7 main beam
2. Bulb for position light
3. Switch
4. Cable with relay
5. Relay
6. Two-point mount
7. Protecting cap
9
Disconnect earth lead (-) from
battery for safety.
Lay and connect wires according to
circuit diagram.
According to circuit diagram
auxiliary lamps are switched on
together with the existing main
beams.
Have the driving lamps adjusted
at a workshop or service station.
Only properly adjusted lamps
provide optimum illumination.
According to circuit diagram
auxiliary lamps can be switched on
in addition to the main beams with a
separate switch.
According to circuit diagram
I the position lamps are wired up and
switched on together with the
parking light.
The use of the enclosed protective
caps (enclosed where applicable)
is not permissible in areas
governed by German Traffic Laws.
One more tip:
Keep the lenses clean. Dirt can
absorb up to 80% of the light.
You drive more safely when you
can see and be seen well. Do
you have spare bulbs and fuses
in your vehicle?
If you have any questions or
installation problems: Contact
your Hella stockist.
II the
III the