Publicidad
Idiomas disponibles
Idiomas disponibles
♦
Turn the blade guard
(working position). Make sure that the blade
guard
is positioned in such a way that the
blade guard fixture
5 bulges
on the blade guard
(fold-out page).
♦
Ensure that the blade guard fixture
seated in the respective bulge
Fitting the additional handle
CAUTION!
►
For safety reasons, this appliance may only
be used with the additional handle
Failure to do so can lead to serious injury.
The additional handle
onto the left, the right or the top, depending
on the job at hand.
Fitting/changing the roughing/
cutting disc
Always wear protective gloves when
changing cutting/rough grinding discs.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the hole must fit the
attachment flange
without any play. Do not use
a reducer or adapter.
NOTE
►
Use only discs which are free of dirt.
■
Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
■
RISK OF INJURY! Press the spindle locking
button
only when the attachment spindle
is at a complete standstill.
♦
Press the spindle locking button
motor.
♦
Undo the clamping nut
mounting spanner
♦
Place the rough grinding or cutting disc with the
label side towards the appliance on the attach-
ment flange
.
♦
Then replace the clamping nut
ment spindle
with the raised side facing up.
│
GB │ IE
■
12
to the required position
lies over one of the
(see Fig. E
is firmly
.
.
can be screwed
to lock the
using the two-hole
(see fig D).
on the attach-
With thin grinding discs (see fig. 1)
♦
The collar of the clamping nut
so that a thin grinding disc can be fitted safely.
Fig. 1
♦
Press the spindle locking button
motor.
♦
Tighten the clamping nut
mounting spanner
With thick grinding discs (see fig. 2)
Fig. 2
The collar of the clamping nut
so that the grinding disk can be fitted securely onto
the attachment spindle
♦
Lock the attachment spindle
♦
Tighten the clamping nut
tion using the two-hole mounting spanner
NOTE
►
If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
♦
For safety's sake, run the appliance at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.
♦
Check whether all the fastening elements are
correctly fitted.
♦
Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough
grinding discs (including diamond cutting discs)
and the direction of rotation of the appliance
(arrow showing the direction of rotation on the
head) match.
faces upwards
≤ 3,2 mm
to lock the
using the two-hole
.
> 3,2 mm
faces downwards
.
.
in a clockwise direc-
.
PWSA 20-Li F4
12
Publicidad
