GreenWorks G24X2LM41K4X Manual Del Operario página 10

EN
Problem
The machine does
not start.
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
There is a high vi-
bration in the ma-
chine.
The machine stops
during mowing.
* If you cannot find the solution to these problems, go to the
service center.
Possible cause Solution
The battery ca- Charge the battery
pacity is low. pack.
The bail switch is Replace the bail
defective. switch.
The safety key is Put in the safety
not put in. key.
The lawn is rough. Examine the mow-
ing area.
The blade height is Adjust the blade/
not set correctly. cutting height to a
higher position.
Wet grass clip- Wait until the
pings attach to the grass dries before
deck. mowing.
The mulch plug is Install the mulch
missing. plug.
The grass is too Increase the blade/
tall, or the blade cutting height.
height is too low.
The grass catcher Empty the grass
and the blade clippings from the
drags in thick grass catcher.
grass.
The blade is un- Replace the blade.
balanced and
worn.
The motor shaft is 1. Stop the mo-
bent. tor.
2. Remove the
safety key and
battery pack.
3. Inspect for
damage.
4. Repair the ma-
chine before
you start it
again.
The blade height is Increase the blade/
too low. cutting height.
The battery pack is Charge the battery
out of power. pack.
The grass clip- Remove the bat-
pings attach to the tery pack and
deck or the blade. check the deck.
Operation temper- Cool the machine.
ature of the ma-
chine is too high.
English
7 TECHNICAL DATA
Voltage
No load speed
Cutting width
Cutting height
Grass catcher capacity
Weight (without battery
pack)
Measured sound pressure
level
Guaranteed sound power lev-
el
Vibration
Battery model
Charger model
Double-insulated construc-
tion
IPX
8 WARRANTY
(The full warranty terms and conditions can be found on
Greenworks website https://www.greenworkstools.eu)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
purchase. This warranty covers manufacturing faults. A faulty
product under warranty might be either repaired or replaced.
A unit that has been misused or used in other ways then
described in the owner's manual might be rejected for
warranty. Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not affected
by any additional warranty offered by a dealer or retailer.
A faulty product must be returned to the point of purchase in
order to claim for warranty, together with the proof of
purchase (receipt).
9 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name: GLOBGRO AB
Globe Group Europe
Address: Riggaregatan 53, 211 13 Malmö, Sweden
8
48 V
3600 / min
410 mm
25-80 mm
50 L
39.7 lbs 18 kg
L = 83 dB(A) , K = 3
PA
dB(A)
L = 96 dB(A)
WA.d
2 2
＜ 2.5 m/s , K = 1.5 m/s
G24B2/G24B4 and other
BAG series
G24X2C/ G24X2UC2/
G24X2UC4 and other CAG
series
IPX4