Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not go up and down on a slope, mow across the face
of the slope. Be careful when you change the direction on
a slope.
•
Monitor holes, ruts, rocks, and other hidden objects that
can cause you to fall. Remove all obstacles such as rocks
and tree limbs.
•
Make sure that your footing is stable. If you are out of
balance, release the handle switch immediately.
•
Do not mow near drop-offs, ditches, or embankments.
4.5
OPERATION TIPS
•
Do not try to override the operation of the start button or
bail switch.
•
Do not tilt the machine when you start it.
•
Do not put hands or feet near or below the turning parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick grass.
•
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
5
MAINTENANCE
WARNING
Remove the safety key and battery pack(s) from the
machine before maintenance.
WARNING
Keep the motor and battery pack(s) free from grass, leaves
or too much grease.
CAUTION
Use only approved replacement parts.
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
NOTE
Recommended tightening torque (blade): 33-37 Nm.
5.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
English
•
Clean the machine with a dry cloth. Do not use water.
5.2
REPLACE THE BLADE
Figure 9.
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting nut and spacer with a wrench or
socket.
7. Remove the blade.
8. Install the new blade. Make sure that the raised points
engage the hole(s) in the blade.
9. Put in the mounting nut and spacer and tighten them.
5.3
STORE THE MACHINE
•
Remove the safety key.
•
Remove the battery pack(s).
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
6
TROUBLESHOOTING
Problem
The handle is not
in position.
7
WARNING
WARNING
Possible cause
Solution
The bolts are not
Adjust the height
engaged correctly.
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
EN
Publicidad
