HIKOKI RP200SL Instrucciones De Manejo página 10

English
WARNING
1. Ensure that the power source to be utilized conforms to
the power requirements specified on the product
nameplate.
2. Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
3. When the work area is removed from the power source,
use an extension cord of sufficient thickness and rated
capacity. The extension cord should be kept as short as
practicable.
4. Prevent the appliance from sucking in the following:
○ Generated spark during metal grinding or cutting.
○ High temperature things, such as lighted cigarette.
○ Inflammable substances (gasoline, thinner, benzine,
kerosene, paint, etc.), explosive substances
(nitroglycerine, etc.), combustible substances
(aluminum, zinc, magnesium, titanium, red phosphorus,
yellow phosphorus, celluloid, etc.)
○ Sharp things, such as nail and razor.
○ Wood chip, metal, stone, string, etc.
○ Solidification materials, such as cement powder and
toner, and conductive fine dusts, such as metal powder
and carbon powder.
○ Foaming liquids, such as oil, boiling water, chemical
fluid, and detergent. Liquids, such as water and oil. May
cause fires or injuries.
5. Do not use the device with its suction opening
obstructed. The temperature of the motor may rise
abnormally, causing troubles such as deformation of
parts or motor burnout.
6. Do not topple the appliance or do not use it on its side.
May cause electric shock or failures.
NAMES OF PARTS
The numbers in the list below correspond to Fig. 1–Fig. 14.
Switch (on/off/automatic):
1 (RP200YL / RP300YL / RP300YM / RP300YH)
Switch (on/off): (RP200SL)
2 Carry handle
Volume flow control display:
3
(RP300YM / RP300YH)
4 Button for filter cleaning 'PressClean'
5 Suction opening
Socket for power tools:
6
(RP200YL / RP300YL / RP300YM / RP300YH)
7 Sealing cap: (RP300YM / RP300YH)
8 Suction hose
9 Roll protection/side handle
10 Roll brake
11 Container
12 Snap lock
13 Rubber for hose fixing
14 Upper part
15 Storage compartment
16 Nameplate
17 Fleece filter bag
18 Fixtures for filter bag
19 PE disposal bag
20 Round hole
21 Container rim
22 Special filter bag for H-class
23 Accessory fixtures for nozzles and hose
24 Screw
25 Rear end suction hose
26 Front end suction hose
27 Connecting sleeve
28 Auxiliary air slide
29 Air inlet
30 Filter closure
31 Filter cover
32 Filter
33 Filter cage
34 Float
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
RP200SL / RP200YL / RP300YL / RP300YM /
RP300YH: Dust extractor
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools that
have reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling facility.
V
Rated voltage
10