HIKOKI RP200SL Instrucciones De Manejo página 8

English
21.The dust extractor should not be
used or stored outside in wet
conditions.
22.IMPORTANT - This device must
only be used or stored indoors.
23.Acids, acetone and solvents can
corrode the device components.
24. Prior to any servicing work,
clean the device. Switch off the
device after each use and pull
out the mains plug. Ensure the
plug cannot be reconnected
accidentally.
25.Steam cleaners and high-
pressure cleaners must not be
used to clean the device.
26.The inside of the cover must
always be kept dry.
27.Mould contamination can result if
the device is not cleaned for an
extended period, especially if
used in areas where foodstuffs
are processed: Always clean and
disinfect the device immediately
after use.
28.Never open the device outdoors
during rain or storms.
29.Do not use the device outdoors
in cold weather.
30.The device must not be operated
in areas with an explosion
hazard.
31.Ensure that the device is steady.
32.If the extracted air is discharged
into the room, ensure there is an
adequate air change rate (L) in
the room. Observe the
regulations that apply in your
country.
33.Keep the tool socket dry and do
not expose to moisture.
34.Do not plug extension cords
between the dust extractor and
the power tool.
35.When using the tool socket, use
the dust extractor in a dry
environment.
36.CAUTION
This device contains dust that is
harmful to health. Discharge and
maintenance operations
(including disposal of the dust
collection containers) must only
be carried out by qualified
specialists wearing appropriate
protective clothing and
equipment.
37. WARNING - general danger!
38.CAUTION
Do not use the device until you
have read the operating
Instructions.
39. WARNING - Operating
personnel must receive
adequate instruction in the use of
this device and in the materials
for which it is used.
40.Special safety information for
RP 300YM:
Warning sign for machines with
dust class M:
During discharge and
maintenance operations, note
the following: Clean the device
before opening it. Wear a dust
mask. Avoid exposing third
parties to dust. Provide local
filtered forced ventilation. Then
clean the maintenance area. Do
8