HIKOKI N 1810DA Instrucciones De Manejo página 13

D: Install the hook on the other side and securely fasten
with screw.
NOTE
Hook can be used as a hanger.
MAINTENANCE AND INSPECTION
WARNING
Be sure to remove all remaining staples, lock the
trigger, and remove the battery from the stapler before
maintenance and inspection.
1. Removing Staple Jams (Fig. 12)
(1) Remove the battery from the power tool.
(2) Press the stop lever, slide open the magazine base and
remove all remaining staples.
(3) Remove any jammed staples, adhesive of staples,
fragments, and splinters that have collected in the blade
guide with pliers, etc.
(4) Check to ascertain that the push lever works smoothly.
NOTE
After removing staple jams, reload the staples and fire a
test staple.
2. Magazine Inspections
The inside of the magazine needs to be cleaned from
time to time. Slide the magazine base open and remove
adhesive of staples, fragments and splinters that have
collected.
NOTE
Dirt inside the magazine may result in trouble with
movement of staples or cause empty firing.
3. Maintenance chart
ACTION
Clean magazine
and feeder Prevent a jam.
mechanism.
Promote
Keep push lever operator safety
working and efficient
properly. Stapler
operation.
4. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws
be loose, retighten them immediately. Failure to do so
could result in serious hazard.
5. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
6. Cleaning on the outside
When the power tool is stained, wipe with a soft dry
cloth or a cloth moistened with soapy water. Do not use
chloric solvents, gasoline or paint thinner, for they melt
plastics.
7. Storage
Store the power tool and battery in a place in which the
temperature is less than 40°C and out of reach of
children.
NOTE
Storing lithium-ion batteries.
Make sure the lithium-ion batteries have been fully
charged before storing them.
Prolonged storage (3 months or more) of batteries with
a low charge may result in performance deterioration,
significantly reducing battery usage time or rendering
the batteries incapable of holding a charge.
WHY HOW
Blow clean daily.
Blow clean daily.
However, significantly reduced battery usage time may
be recovered by repeatedly charging and using the
batteries two to five times.
If the battery usage time is extremely short despite
repeated charging and use, consider the batteries dead
and purchase new batteries.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
Important notice on the batteries for the HiKOKI
cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used with
batteries other than these designated by us, or when the
battery is disassembled and modified (such as
disassembly and replacement of cells or other internal
parts).
GUARANTEE
We guarantee HiKOKI Power Tools in accordance with
statutory/country specific regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the Power Tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling
instruction, to a HiKOKI Authorized Service Center.
13
English