Evolution F255 SMS Instrucciones Originales página 29

www.evolutionpowertools.com
When cutting operations are completed,
return the cutting head to the vertical position
and return the 33.9˚ Bevel Pin to its outer
(disengaged) position.
CUTTING BOWED MATERIAL (Fig. 63)
WARNING: Before cutting any work-piece,
check to see if it is bowed. If it is bowed the
work-piece must be positioned and cut as
shown.
Do not position the work-piece incorrectly or
cut the work-piece without the support of the
Fence.
CLEARING JAMMED MATERIAL
• Turn mitre saw "OFF" by releasing the
trigger switch.
• Allow the blade to come to a complete halt.
• Unplug the mitre saw from the mains supply.
• Carefully remove any jammed material from
the machine.
• Check the condition and operation of the
safety guard.
• Check for any other damage to any part of
the machine e.g. the blade.
• Have any damaged parts replaced by
a competent technician and a safety
inspection carried out before using the
machine again.
The free end of a long work-piece should be
supported at the same height as the machines
rotary table. The operator should consider
using a remote work-piece support stand,
adjustable workmate or saw horse etc.
OPTIONAL EVOLUTION ACCESSORIES
DUST BAG (Supplied with R255SMS+)
A Dust Bag can be fitted to the extraction port
at the rear of the machine. The Dust Bag is for
use when cutting wooden materials only.
• Slide the Dust Bag over the dust extraction
port, ensuring that the spring clip grips the
port holding the Dust Bag securely in place.
(Fig. 64)
Note: For operational efficiency empty
the Dust Bag when it becomes 2/3 full.
Dispose of the contents of the Dust Bag in an
environmentally responsible way. It may be
necessary to wear a dust mask when emptying
the Dust Bag.
Note: A workshop vacuum extraction machine
can be attached to the dust extraction
port if required. Follow the manufacturers
instructions if such a machine is fitted.
WARNING: Do not use the Dust Bag when
cutting metallic materials including wood
with nails.
EXTRACTION PORT ADAPTOR
TUBE (Supplied with R255SMS+)
Use the Adaptor Tube to connect the
extraction port of the machine to suitable
commercial workshop vacuum extraction
equipment (not supplied) which have ø30mm
internal bore hoses or inlet ports.
MAINTENANCE
Note: Any maintenance must be carried
out with the machine switched off and
disconnected from the mains/battery
power supply.
Check that all safety features and guards
operating correctly on a regular basis. Only use
this machine if all guards/safety features are
fully operational.
All motor bearings in this machine are
lubricated for life. No further lubrication
is required.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean
by inserting pointed objects through
openings in the machines casings etc. The
machines air vents should be cleaned using
compressed dry air.
Excessive sparking may indicate the presence
of dirt in the motor or worn out carbon
brushes. If this is suspected have the machine
serviced and the brushes replaced by a
qualified technician.
ENVIRONMENTAL PROTECTION
(6.4)
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
29
EN