Descargar Imprimir esta página

Baker Hughes Druck ADTS542F Instrucciones De Seguridad E Instalación página 12

Ocultar thumbs Ver también para Druck ADTS542F:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
4.
To disconnect power to the test set, either:
a.
Remove the power cable (5) from the front of the test set, or
b.
Remove the power cable from the wall socket. The wall socket connection must remain
accessible.
3.2 External Functional Earth/Ground Terminal
An external earth/ground connection stud (6) is available as a functional earth on the front panel
providing a connection/bonding point for other equipment to be connected to the same
earth/ground connection as the test set (This is not a protective earth/ground connection).
3.3 Pneumatic Connections
No external pneumatic pressures or vacuums are required as the ADTS contains internal
pressure and vacuum pumps.
Hoses (available as orderable accessories on the datasheet) are used for connection to the
"Pitot" (Pt) (1) and "Static" (Ps) (2) output ports of the ADTS.
The "Pitot" (Pt) and "Static" (Ps) outputs can then be connected to the corresponding Pitot and
Static connectors on the aircraft or aeronautical instruments.
The maximum Pt and Ps output pressure is 2 bar absolute.
The following table details the possible connector specifications:
Mating female parts are available from Druck.
3.4 Cleaning
CAUTION
The following materials are approved cleaning agents:
Note: Equivalent alternatives may be used for listed items.
1.
Clean the external surfaces of the unit using lint-free cloth and a soft brush. Remove
stubborn dirt using a damp cloth and mild detergent and allow to dry.
2.
Clean the electrical connector using a soft brush. Remove stubborn dirt using a damp cloth
and mild detergent and allow to dry.
Copyright 2014 Baker Hughes Company.
10 | ADTS542F/552F/553F/554F Safety and Installation Guide–English
Name
G1/8
Pipe Thread ISO 228 - G 1/8 B
AN3
AN4
AN6
Do not use solvents to clean this equipment.
Material
Lint-free cloth
Damp cloth
Mild detergent
Soft brush
Specification
3/8 - 24 UNJF - 3A Thread
7/16 - 20 UNJF - 3A Thread
9/16 - 18 UNJF - 3A Thread
Specification
Commercially available
-
Commercially available
Commercially available

Publicidad

loading