Publicidad
Idiomas disponibles
Idiomas disponibles
The ADTSTOUCH can contain one Lithium-ion battery which is housed in the battery
compartment of the ADTSTOUCH.
2.1 Replacing the Battery
Note: Only use batteries that have been supplied by or purchased from Druck.
Prior to replacing the battery, switch the ADTSTOUCH off. If the ADTSTOUCH is connected to
the umbilical cable or Docking connector, disconnect prior to removing the battery cover plate.
1.
Unscrew the two thumbscrews (5) of the battery compartment cover plate and remove the
cover plate.
CAUTION
ADTSTOUCH is tilted with the battery compartment facing downwards, the
battery can fall out of the ADTSTOUCH causing damage to the battery.
2.
Use the tab attached to the battery to slide the battery out of the battery compartment.
3.
Fit a new or re-charged battery into the battery compartment, observing the keyed
orientation.
Figure 3: ADTSTOUCH Umbilical Cable Connector
Figure 4: ADTSTOUCH Battery Compartment
When the battery compartment cover plate is removed and the
4
5
English–ADTS542F/552F/553F/554F Safety and Installation Guide | 5
5
Copyright 2014 Baker Hughes Company.
Publicidad
