Gardena 1285 Instrucciones De Empleo página 11

6 . STORAGE
6.1 To put into storage:
The product must be stored away from
children.
The GARDENA Irrigation Valve are intended
for outdoor use and are only frost-proof to
a limited extent. The only way to protect your
Irrigation Valves completely is to remove
the valves before the frosty season begins.
Alternatively, the pipe system can be emp-
tied before and after the Irrigation Valve.
1. Remove the battery to preserve it
(see 3. Initial Operation).
2. Store the Irrigation Valve in a dry, enclosed
and frost-free place.
6.2 To empty the pipeline system:
6.2.1 To empty the pipeline system UPSTREAM
of the valve:
1. Turn off the tap and disconnect the hose
between the tap and the GARDENA Water
Connection Point Art. 2722 / Art. 2795.
This allows the air to flow freely.
GAR_01285-63.960.02_2024-04-25.indb 11 GAR_01285-63.960.02_2024-04-25.indb 11
2. If the watering system is directly connected to
the water tap, turn off the water supply and open
the venting tap.
3. Set the selection lever
position.
4. If you are using the GARDENA Valve Box V3, make
sure that you open the integrated drain cap.
6.2.2 To empty the pipeline system
DOWNSTREAM of the valve:
Requirement: The Drainage Valve must be
installed deeper than or at the same depth as
the Irrigation Valve.
v Install the GARDENA Drainage Valve Art. 2760
immediately after the valve.
The system is drained automatically via the the
GARDENA Drainage Valve.
CAUTION!
If neither of these requirements is fulfilled,
the valve must be removed and stored in
a place safe from frost.
(13) of all valves to the ON
11
25.04.24 09:03 25.04.24 09:03