Kärcher KM 75/40 W Bp Manual De Instrucciones página 20

Adjust the raising of the bulk waste flap
– Adjustment is necessary if the bulk
waste flap cannot be raised wide
enough.
– The Bowden cable needs to be re-
leased a little if the sweeper results be-
come poorer, for e.g. due to the wearing
of the front lip.
 Open the device hood.
 Loosen counter-nut.
 Adjust the adjustment screw.
 Tighten the counter-nut.
Adjusting and replacing sealing strips
Note: Remove the waste container and
move the pushing handle to the front prior
to tilting the appliance. Do not rest the ap-
pliance on the pushing handle.
 Front sealing strip
 Loosen the fastening screws of the
sealing strip.
 Adjust or replace sealing strip.
 Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 0-10 mm.
 Adjust sealing strip.
 Tighten the fastening of the sealing
strip.
 Rear sealing strip
 Remove the waste container.
 Loosen the fastening screws of the
sealing strip.
 Adjust or replace sealing strip.
 Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 0-10 mm.
 Tighten the fastening of the sealing
strip.
 Side sealing strips
 Loosen the fastening screws of the
sealing strip.
 Adjust or replace sealing strip.
 To set the floor clearance, insert a
sheet with a thickness of max. 2 mm un-
der the sealing strip.
 Adjust sealing strip.
 Tighten the fastening of the sealing
strip.
20
Replacing dust filter
WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
CAUTION
Risk of damage!
 Do not rinse out the dust filter.
 Lock parking brake.
 Shake off dust filter.
 Open the locking screw of the dust filter
cover in an anticlockwise direction.
 Lift the dust filter cover.
 Replace dust filter Make sure the dust
filter is inserted correctly (see figure).
 Screw in the locking screw all the way.
CAUTION
If the locking screw is not tightened all the
way, there may be damages.
Note: Make sure when installing the new
filter that the fins are not damaged.
Replace fuse/relay
 KM 75/40 W Bp
1 Fuse F1 (50 A)
2 Fuse F2 (2 A)
3 Relay
4 Battery charge plug
 Open the cover.
 Replace defective fuse or relay.
 KM 75/40 W Bp Pack
The fuse is located on the battery terminal.
8
-
EN
Accessories
Side-brushes, soft
For fine dust on inside surfaces; wetness
resistant.
Roller-brush, soft
With natural bristles: especially for sweep-
ing fine dust on smooth floors indoors.
Not resistant to wetness; do not use on
abrasive surfaces!
Roller-brush, hard
For removing stubborn dirt in the external
area; resistant to moisture.
Roller brush, antistatic
For statically chargeable surfaces such as
carpet or artificial turf
Carpet sweeping unit
Includes: Lint trap, antistatic roller brush,
triple steering roller
6.905-626.0
6.906-886.0
6.906-885.0
6.906-950.0
2.641-571.0