Cameo F2 FC PLUS Manual De Usuario página 13

ENTER - 1. Press ENTER to access the menu for selecting the operating mode. 2. Press ENTER to
move down one level in the menu structure. 3. Press ENTER to confirm a value change, such as
changing the DMX address.
SELECT - Turn the encoder to select menu items and change the value of a menu item (e.g. DMX
address).
8
The functions assigned to the centre encoder (turn and press) is shown in the centre of the
screen in the corresponding menu (centre line = turn, bottom line = press).
9 ESC - If the push function of the right rotary-push encoder is not explicitly stated at the bot-
tom right of the display, press the encoder to move up one level in the menu structure.
10 ZOOM
On either side of the housing is a calibration knob for manually adjusting the dispersion. The two
controls are mechanically linked and are directly opposite each other on the housing. Turn the ca-
libration knob to adjust the dispersion of the light continuously from 53° to 17°. A rack and pinion
system moves the zoom tube with the Fresnel lens in and out of the housing. The further the zoom
tube protrudes from the housing, the narrower the dispersion. A stop mechanism prevents the
tube from becoming detached from the housing.
OPERATION
• As soon as the light is correctly connected to the power supply, the following will
be displayed in succession: "Welcome to Cameo", model name and software
version. After this process, the light is operational and starts up in the previously
selected mode.
• If one of the DMX modes or slave mode is enabled and no control signal is present
at the DMX input, the characters in the display will start to flash.
• If no input is made for approx. 1 minute, the currently activated mode is automati-
cally shown on the display (main screen).
MAIN SCREEN: DMX MODE
In DMX mode, the main screen shows the currently set DMX start address, the DMX mode and
other information (see illustration).
13