Kingfisher CLFS7KGWUK Manual Del Usuario página 32

Issue
The appliance does not
spin.
Excessive noise is heard
during the spin cycle.
Recycling & disposal
Waste electrical products (WEEE) should not be disposed of with household waste. Please recycle
where facilities exist. Check with your local governmental authority, domestic waste disposal
services or the retailer where the product was bought for recycling advice. The wheelie bin symbol
on the product or its packaging indicates that this product cannot be treated as normal household
waste. This product must be handed over to an electric and electronic equipment collection point
for recycling.
Product Safety
WARNING: THIS APPLIANCE IS DESIGNED FOR THE WASHING OF
CLOTHES AND OTHER GARMENTS ONLY. DO NOT USE THIS APPLIANCE
TO WASH SHOES, RUGS OR MATS WITH RUBBER BACKING.
Availability of Spare Parts
Dependent upon the spare part, these are available for a minimum period of seven years for professional
repairers or a minimum of ten years for professional repairers and end-users. Contact the Customer Service
helpline for assistance or visit:
www.kingfisherspares.com
For assistance, contact the Customer Services helpline:
UK 0800 324 7818 uk@kingfisherservice.com
Eire 1800 932 230 eire@kingfisherservice.com
Further information about this appliance can also be found at:
www.kingfisher.com/products
5059340794501_MNL_IN_V09.indb 32 5059340794501_MNL_IN_V09.indb 32
Possible Cause and Solution
The appliance is fitted with a detection system that protects it from damage by
balancing the load correctly in the drum before spinning. The appliance will:
• Attempt to balance the load, and increase the spin duration.
• Reduce the rotation speed to decrease vibration and noise.
• Abort the spin if unsuccessful.
If this is experienced, pump out the water from the drum, open the door and
redistribute the clothes manually before trying again.
See Error 3 above and check the water has been pumped out of the
appliance.
Ensure a "no-spin" program was not selected.
Excessive detergent can affect the spin cycle, ensure the correct amount is
being used.
Ensure the appliance is completely level and if necessary, adjust the feet.
Ensure the transit screws, rubber bungs and spacer tubes were removed.
during installation.
Ensure there are no foreign objects inside the drum such as coins or keys.
32
09-08-2023 13:08:03 09-08-2023 13:08:03