Publicidad
Idiomas disponibles
Idiomas disponibles
7.- FITTING THE HANDLEBAR.-
Loosen
the
screws
handlebar stem (3).
Position the handlebar (4) on the
handlebar stem (3), Fig.6, tighten the
knob (5) and then insert the handlebar
stem (3) into the hole on the main
body (54), Fig.7. Position it correctly
and then tighten knob (55-56) by
turning it clockwise.
Plug connector (13), coming out of the
main post (3), into connector (58),
coming out of the boss on the main
body (54) Fig.7. Place the cap (14)
and secure with screws (12).
ADJUSTING THE HANDLEBAR
HORIZONTALLY.-
Position the handlebar (4) at a
comfortable
distance
exercise but without going beyond the
"MIN INSERT" marks, now tighten
knob (5) securely, Fig.8.
ADJUSTING THE HANDLEBAR
VERTICALLY.-
Position the handlebar (4) at a
comfortable
distance
exercise but without going beyond the
"MIN INSERT" marks, now tighten
knob (55-56) securely, Fig.8.
Important:
This
tensioning
equipped with an emergency braking
system which, when applied with force
(as shown by the arrow in Fig 8),
produces a much sharper braking
effect.
8.- ATTACHING THE BOTTLE
HOLDER.-
Take the bottle holder (63) along with
the two screws (64) and screw them
(12)
of
the
for
doing
for
doing
control
(90)
on to the side of the handrail (54)
Fig.9.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (25)(71) up or down,
as shown in Fig.10.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (21)
Fig.11, to make it easier to move. The
wheels located at the front of your unit
make it easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.11. Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINTAINING THE MACHINE.-
1.
For health reasons it is necessary
to clean the handlebars and seat after
each class with a disinfectant spray,
as well as removing any sweat from
the bicycle's frame.
2. CHECKING THE TIGHTENING
KNOBS.-
The 3 tightening knobs should be
loosened off and sprayed with a
is
lubricant to ensure that they remain
operative.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
10
Publicidad
