Publicidad
Idiomas disponibles
Idiomas disponibles
1.- ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is recommended when assembling
this unit.
Take the unit out of its box and make
sure that all of the pieces are there
Fig.1: (54) Main body; (1) Monitor; (3)
Handlebar stem; (4) Handlebar; (5)
Knob the handlebar; (6) Flat washer;
(24) Front stabiliser bar with wheels;
(70) Rear stabiliser bar with adjustable
feet; (89) Saddle; (51L) Left pedal;
(51R) Right pedal; (15) Slot head bolt
M-10; Double ended spanner.
2. Position the machine's rear stand
on the rear stabiliser bar (70), as
shown in Fig.2, insert the bolts (15)
and then tighten securely.
3. Position the front stabiliser bar with
wheels (24), paying attention to the
red dots and with the wheels facing
forwards, as shown in Fig.2, insert the
bolts (15) and tighten securely.
4.- FITTING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal, marked with the
letter (51R), screws onto the right-hand
crank, also marked with an (R), in a
clockwise direction. Tighten securely,
Fig.3.
The left-hand pedal, marked with the
letter (51L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely, Fig.3.
5.- ATTACHING THE SADDLE.-
Fit the saddle bracket (89), Fig.3, onto
the horizontal saddle tube (3), as
shown in Fig.3, fit the saddle into
position and tighten the nuts on the
bracket securely.
ADJUSTING THE SADDLE HEIGHT.-
Loosen the saddle post adjustment
knob
(61)
anticlockwise, Fig.3, move the saddle
to a position comfortable for doing
exercise
and
adjustment knob (61) securely by
turning it clockwise.
HORIZONTAL ADJUSTMENT OF
THE SADDLE.-
Loosen the knob (88) slightly by
turning it anticlockwise, Fig.3, move
the saddle to a position comfortable
for doing exercise and then tighten the
knob (88) securely by turning it
clockwise.
6.- FITTING THE MONITOR.-
Take the monitor (1) and remove the
four screws (2) from the base of the
monitor, Fig.4. Place the monitor (1) in
the direction of the arrow sliding the
monitor on the holding plate.
Connect the terminal (13) in terminal
of the rear part of the monitor (1)
Fig.4, and attach it using the four
screws (2) removed previously.
Once the monitor is assembled attach
the post covers (7 and 8) as shown in
Fig.5, and tighten the screws (10)
securely.
9
direction.
slightly
by
turning
then
tighten
Tighten
it
the
Publicidad
