Orbegozo DS 57190 B IN Manual De Instrucciones página 16

DS 57190 B IN
Oil leakage One w ay valve and t he air
vent ilat ion ent rance are not t ight ly
sealed
Leakage from t he connect ion of U-
shaped sect ion and cover
Shake of t he body The leaf damaged and causes
shaking
The mot or is not t ight ly hanged
The body is not t ight ly hanged
Insufficient The dist ance bet w een t he body and
suct ion t he gas t op t oo long
Too much vent ilat ion from open
doors or w indow s
The machine The fixing screw not t ight enough
inclines
The hanging screw not t ight enough
(11).ELECTRICAL DIAGRAM.
(12). MAIN PARAMETERS
Rat ed Input 220V-240V, 50Hz
Rat ed Pow er 195W
Light ing Pow er 2.5W X 2
Mot or Pow er 190W
Drive Mode Single Mot or
Speed Speed I Speed II Speed III
Air t ube diameter 150MM
Air out put
642.4m3/h
≥
Air pressure
359Pa
≥
Noise 70dB(A)
Disposal of old electrical appliances.
The European direct ive 2002/96/EC on Wast e Elect rical and Elect ronic Equipment (WEEE), requires
t hat old household electrical appliances must not be disposed of in the normal unsort ed municipal
w ast e st ream. Old appliances must be collect ed separat ely in order t o opt imize t he recovery and
recycling of t he mat erials t hey cont ain, and reduce t he impact on human healt h and t he environment.
The crossed out " w heeled bin" symbol on t he product reminds you of your obligat ion, t hat w hen you dispose
of t he appliance, it must be separat ely collect ed.
Consumers should cont act t heir local aut horit y or ret ailer for informat ion concerning t he correct disposal of
t heir old appliance.
DECLARATION OF CONFORMITY:
This device complies w ith the requirements of the Low Voltage Directive 2014/35/ EU and the requirements
of the EMC directive 2014/ 30/ EU.
Take dow n t he one w ay valve and seal w ith glue
Take U-shaped sect ion dow n and seal w it h soap
or paint
Replace t he leaf
Lock t he mot or t ight ly
Fixed the body t ight ly
Readjust t he dist ance
Choose a new place and resemble t he machine
Tight en t he hanging screw and make it horizont al
Tight en t he hanging screw and make it horizont al
https://manual-hub.com/
16