HT Instruments HT4011 Manual De Instrucciones página 35

5.4. RESISTANCE MEASUREMENT
Before attempting any resistance measurement, remove power from the
circuit under test and discharge all capacitors, if present.
1. Select the position
2. Insert the red cable into input terminal V
terminal COM.
3. Position the test leads in the desired points of the circuit to be measured (see Fig. 6).
The display shows the value of resistance
4. If the symbol "O.L" is displayed, this indicates overload status.
5. To use the HOLD function, please refer to § 4.2.
Fig. 6: Use of the clamp for Resistance measurement
CAUTION
CAPHz% and the black cable into input
EN – 11
HT4011