Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTIONS
1. The induction hotplate must be installed by qualified personnel or technicians. We have professionals at your
service. Please never conduct the operation by yourself.
2. The hob will not be installed directly above a dishwasher, fridge, freezer, washing machine or clothes dryer, as the
humidity may damage the hob electronics.
3. The induction hotplate shall be installed such that better heat radiation can be ensured to enhance its reliability.
4. The wall and induced heating zone above the table surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
6. A steam cleaner is not to be used.
Connecting the Hob to the Mains Power Supply
This hob must be connected to the mains power supply only by a suitably qualified person. Before
connecting the hob to the mains power supply, check that:
1. The domestic wiring system is suitable for the power drawn by the hob.
2. The voltage corresponds to the value given in the rating plate.
3. The power supply cable sections can withstand the load specified on the rating plate. To connect the
hob to the mains power supply, do not use adapters, reducers, or branching devices, as they can cause
overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its temperature
will not exceed 75˚C at any point.
Check with an electrician whether the domestic wiring system is suitable without alterations. Any
alterations must only be made by a qualified electrician.
L1
L2
N2
N1
380-415V~
220-240V~
220-240V~
• If the cable is damaged or to be replaced, the operation must be carried out the by after-sale agent with dedicated
tools to avoid any accidents.
• If the appliance is being connected directly to the mains an omnipolar circuit-breaker must be installed with a
minimum opening of 3mm between contacts.
• The installer must ensure that the correct electrical connection has been made and that it is compliant with safety
regulations.
• The cable must not be bent or compressed.
• The cable must be checked regularly and replaced by authorised technicians.
The bottom surface and the power cord of the hob are not accessible after installation.
GND
L
N
GND
220-240V~
14
L1
L2
N
GND
380-415V~
220-240V~
220-240V~
V.1
Publicidad
