Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
The equipment does not
switch ON.
The equipment stops or slows
down when processing the
product.
The processed product
remains inside the equipment.
Irregular cut.
Burnt smell or smoke.
Damaged cord.
Abnormal noises.
8
TABLE 04
CAUSES
Wrong starting procedure.
Motor thermal protection
turned ON.
Electricity shortage.
Problem with the electric circuit.
The belt is sliding.
The safety device on the lid
contact is failing.
Problem with the electric motor.
The expeller dish is missing.
Off load throat obstructed.
Blunt blades or damaged
blades.
Problem with the electric circuit. Call Technical Assistance.
Problems with equipment
transportation.
Problem with the bearings.
SOLUTIONS
Read item 3.1 Starting.
Wait some minutes and try
again.
Check network.
Call Technical Assistance.
Adjust the belt tension.
Call Technical Assistance.
Place the dish.
Clean the throat.
Change the plate.
Call Technical Assistance.
Call Technical Assistance.
Publicidad
