RIDGID R6791 Guia De Inicio Rapido

R6791/R6791VN QUICK START GUIDE
WARNING:
This Quick Reference Guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand operator's manual before using
this product. All page references refer to the operator's manual, where you can find detailed instructions for performing each step mentioned below.
1
1
Install desired bit. (See page 6)
A
B
C
A - Adjustable nosepiece (wood)
B - Feed housing
C - Bit
D - Bit load button
998000092
12-30-19 (REV:02)
2 Change nosepiece, if necessary, and set desired
1
screw length. Retighten screw securely to make
sure nosepiece is secure. (See page 7)
A
D
D
A - Nosepiece screw
B - Adjustable nosepiece (drywall)
C - Adjustable nosepiece (wood)
D - Feed housing edge
DO NOT RETURN TO THE STORE!
If you have any questions, please call: 1-866-539-1710
or visit our website at www.ridgid.com
3 Verify screw tops are resting against collated
1
tape material as shown below, then load collated
screws into screwdriver. (See page 7)
4
7
A
B
D
B
C
C
A - Feed housing
B - Screw guard
C - Strip guide
D - Second empty hole aligned with bit
4
1
Adjust depth of drive, if needed. (See page 7)
A
A - Increase depth
B - Decrease depth
C - Depth of drive adjustment thumbwheel
Set desired forward/reverse switch direction,
5
1
secure workpiece, and plug in screwdriver.
Depress switch trigger to start, THEN press
nosepiece against work surface with constant
force to drive screw. When bit stops rotating,
remove from work surface and proceed to next
position, keeping switch trigger depressed to
autofeed the next screw. (See page 7)
90°
C
B