Publicidad
Idiomas disponibles
Idiomas disponibles
4.2 FILTER CLEANING
▌
1
1. Shut off the water supply.
2. Use a coin or flat-head screwdriver to unscrew the filter and take it out.
3. Please use a brush and water to gently remove the clog.
4. Install the filter back on.
5. Turn open the water inlet valve.
4.3 DESCALING MODE
▌
Descaling process will reduce or eliminate limescale deposits inside water path (hoses, water tank, instant heater and
nozzle tip). It is needed that the user adds some quantity of descaling agent (descaling powder) through the hole in the
main body case
1
3s
1. Press knob button and water temperature button at the same time about 2 seconds or longer to activation descaling
process.
2. Open the lid and the descaler cover from the main body case of the device
3. Pour powder agent.
4. Wait 30 sec to allow to dilute the descaling agent.
5. During the cleaning process, each cleaning step takes about 1 minute. The automatic cleaning, the front cleaning and
the rear cleaning will repeat the cycle three times for descaling cleaning (9 times in total). The whole process takes
about 10 minutes.
6. Repeat the enhanced cleaning automatic cleaning, front washing, and rear cleaning. The cleaning time is about 2
minutes each time, and the process takes about 6 minutes.
7. The device will make 2 beeps signal to indicate the process is end.
Note: During this process, no function should work.
Please use one of the following descaling agents at specified concentration. (Failure to do so may cause damage)
2
3
2
26
4
3
30 min.
5
x2
Publicidad
