Publicidad
Idiomas disponibles
Idiomas disponibles
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.
Cleaning and maintaining the
safety cutter bar
Tools and aids required
• Cloth
• Care oil spray
Care after each use
• Remove any green cuttings that are
stuck.
• Clean the safety cutter bar (2) with an
oily cloth.
• Maintain the safety cutter bar (2) with
a care oil spray.
Maintenance
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts. Ensure that the screws
in the safety cutter bar (2) are firmly in
place.
• Check the covers and protective
devices (1/3) for damage and correct
fit. Replace these if necessary or have
them repaired by the service centre.
• You can smooth out slight nicks on the
cutting teeth yourself. To do this, pull
off the cutting edges with an oil stone.
Only sharp cutting teeth provide a
good cutting performance.
• Blunt, bent or damaged safety cutter
bars must be replaced.
Have any work that is not described in this
instruction manual performed by our ser-
vice centre. Only use original parts.
Maintenance
Tools and aids required
• Hand protection (3, Spare parts and
accessories, p. 32)
• Phillips screwdriver (Size 2 PH)
Replacing the hand protection
(Fig. C)
1. Loosen the two screws of the hand pro-
tection (3) with a screwdriver.
2. Replace the damaged hand protection
(3).
3. Fasten the new hand protection (3)
with the two screws.
Storage
Always store the device:
• clean
• dry
• protected against dust
• in the blade encasing (11)
• out of the reach of children
GB
MT
29
Publicidad
